Chino IR-HA Series, Инструкция по эксплуатации

Страница: 25 / 52

INST.No.INE-567-P1CE
-17-
6.4.2 Attenuation Rate Setting
(This is only valid if "PEAk" is selected for signal modulation)
1) From setting mode display, push
SEL
key several times to
display "dEC" on the sub display.
2) Numeric value on the main display blinks in the order of
0→2→5→10(°C/ sec) when

key is pushed and
0→10→5→2(°C/ sec) when

key is pushed.
3) Blinking stops by pushing
ENT
key and the registration is
completed.
6.5 Temperature Unit Selection
Select ºC or ºF for measuring temperature unit.
1) From setting mode display, push
SEL
key several times to
display "unit" on the sub display.
2) Push  key or  key to select "C (
ºC)" or "F (ºF)".
3) Blinking stops by pushing
ENT
key and the registration is completed.
6.6 Thermocouple Measurement Selection
This setting is used to perform measurement with K thermocouple, sold separately (refer to "11.1
Thermocouple").
1) From setting mode display, push
SEL
key several times to
display "tC" on the sub display.
2) Push

key or

key to select whether or not to perform
thermocouple measurement.
3) Blinking stops by pushing
ENT
key and the registration is completed.
Remark
Remark
Remark Setting of factory default is "0"°C/sec (Hold the highest temperature at
measuring (HOLD)).
Setting of factory default is "oFF" (No
thermocouple measurement).
[Thermocouple measurement
selection display]
Tb CONT MEM PEAK
[Attenuation rate setting
display]
Tb CONT MEM PEAK
Setting of factory default is "
C (
ºC)
".
[Temperature Unit selection display]
Tb CONT MEM PEAK