Rev. 01 of 08/08/2013_CP Page 4 of 15
IR IRRADIANCE
The model Infra 750 is equipped with three lamps whose filament reaches the colour temperature of 2450
K.
The infrared irradiance peak is in correspondence to the wave lenght of 1200 nm.
INFRARED IRRADIATION INTENSITY OF ONE SINGLE LAMP OF 250W:
- at 20 cm: 340 mW/cm2
- at 30 cm: 170 mW/cm2
- at 40 cm: 100 mW/cm2
- at 50 cm: 70 mW/cm2
The tolerance on these values is ± 20%
COMPOSITION OF THE METALLIC PARTS
• LAMP BODY : electrostatic painted iron
• TUBES : chromated / electrostatic painted iron
• WHEELS OF BASE : plastic
ASSEMBLING
Insert the end with two holes of the white painted tube in the transverse tube of the base (be careful that
the hole of at the top of the white tube is in back position) tightening the two screws (after inserting insert
the toothed washer “A” and smooth wather “B” to the two bolts through the holes of tube and base.
Tight strongly with a spanner.
Insert the side with stop of the chromated tube into the top end of the painted tube until its stop, so that
the two holes are lined up. String the plated washer into the hexagonal head 8MA bolt (Group "B"), insert
the bolt with the washer into the two lined up holes and screw it strong with a spanner.
Turn out the cut head 3MA screw of the top end of the chromated tube.
Screw off the knob back of the lamp-hold fork and insert the fork into the chromated tube.
Stop the fork on the tube at the wanted height by screwing the back knob. Turn the cut head screw in
again.
Insert the metallic washer between the knob and the fork hole and the black rubber washer between fork
and lamp hole. Screw the two knobs strongly to fix the body of the lamp.
Apply the black handle at the top of the device fixing it with the screws after inserting the toothed washer
“C” and smooth washer “D” .
