Rev. 01 of 08/08/2013_CP Page 12 of 15
PERIODIC CHECK OF THE TIGHTINESS OF THE SCHEME ASSEMBLED PARTS: Frequency of operation
Every 3 month or before, if there is anomalous/excessive movement of the connected parts.
Procedure
Check the tightness of the side knobs, the rear fork and the point of connection between base and vertical
tubes.
BREAKDOWNS AND REPAIRS
ATTENTION
NO MODIFY OF THIS DEVICE IS ALLOWED;
BREAKDOWNS AND REPAIRS IMPLEMENTABLE ALSO BY NO-SPECIALIZED PERSONS.
For safety reasons for every maintenance operation it’s necessary to disconnect the cable plug to the
network socket.
1° CASE: After inserting the cable plug into the network socket, the green circle warning light doesn’t turn
on.
Repair: turn in clock-wise sense both timers place on ”I” position the green switches and then check if the
IR emitters ignite.
In case of ignition, call a specialized repairator for the green warning light replacement.
In case of no ignition, check the wall socket; if it’s functioning check the efficiency of the two fuses placed
into the socket block back side of the lamp. If they are interrupted, replace them with new fuses
proceeding as following described. If the fuses are correctly operating, call an authorized service center.
2° CASE: Inserting the cable plug into the network socket, the green warning light turns on, but, after
having turned both timers and pressed the ON/OFF switches, there isn’t ignition:
-
Of all the three IR emitters: call a an authorized service center or Chinesport for the
reparation.
-
One or two IR emitters: check if the correspondent switches are on the "ON" position and
their green light is ignited. If so, before replacing the bulbs, verify that they are correctly screwed in
their lamp holder (for the control and replacement of the bulb proceed as following described).
If the replaced bulbs still doesn’t ignite, it will be necessary to call an authorized service center.
