CHIEF SLEU PROJECTOR LIFT, Руководство по эксплуатации

Страница: 14 / 21

Installation Instructions SLEU
7
8. Using two people orient lift so that flanged side is facing
down and motor and electrical junction box are facing away
from target.
NOTE:
Verify lift is in proper orientation with lift front facing
target and flanged side down. (See figure 6)
9. Position and align lift under opening. (See figure 6)
10. Screw three jam nuts on to threaded rods.
NOTE:
Jam nuts should be located on rod so that flange of lift
housing is seated against ceiling when cover plate
rests against jam nuts.
11. Carefully raise and position lift so that mounting holes for
threaded rods in lift top cover are aligned with threaded rods
installed in ceiling. (See figure 6)
Figure 6
12. Level lift
CAUTION:
The lift must be installed square and parallel.
Avoid stressing the lift during installation.
Figure 7
Installation in a Suspended Ceiling
(using pipe coupler)
The SLEU can be installed by hanging from a 1 1/2" NPT Pipe
and coupling. If this installation is desired contact a Chief
Customer Service Representative and order the optional
mounting kit Model SMA-600.
Installation in a Wood Framework
The lift housing is designed with joist tabs to allow mounting of
the lift to ceiling joists or other wooden framework.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the lift is being
mounted is capable of supporting 5 times the weight of the lift
and all attached equipment.
WARNING:
LIFT WEIGHS IN EXCESS OF 65 LBS
(30KG)! ALWAYS use two people and an appropriate lifting
device, and proper lifting techniques when installing or
handling this lift.
1. Verify lift housing will properly fit within wooden ceiling joists
or construct a framework and secure it to the joists.
(See figure 1)
NOTE:
The lift only requires support on two opposing sides.
2. Using two people, orient lift so that flanged side is at top.
3. Remove four caps on lift pan. (See figure 8)
4. Remove four Phillips pan head screws securing pan to lift
and set aside for reuse. (See figure 8)
5. Remove pan off lift and set aside. (See figure 8)
3/8" Threaded Rod
Flange
3/8" Threaded Rods
Jam Nut