CHIEF SLEU PROJECTOR LIFT, Руководство по эксплуатации

Страница: 15 / 21

SLEU Installation Instructions
8
Figure 8
6. Using two people orient lift so that flanged side is facing
down and motor and electrical junction box are facing away
from target.
7. Using an appropriate lifting device, carefully raise and
position lift so that mounting tabs in lift housing are aligned
with wood trusses, and flange on lift housing is seated
against ceiling.
Figure 9
CAUTION:
The lift must be installed square and parallel.
Avoid stressing the lift during installation.
8. Verify lift is level and is square in alignment.
9. Secure the lift to the joists or wood framework using four,
six, or ten 1/4 x1-1/4" lag screws.
IMPORTANT ! :
Lag screws must be driven through mounting
tabs in lift housing.
Figure 10
Mount Projector To Lift
The SLEU is designed to accommodate the installation of
projectors that have been equipped with an appropriate
interface bracket.
IMPORTANT ! :
If the projector being mounted does not have
the required interface bracket or the bracket will not work
properly, immediately contact a Chief Customer Service
representative by calling the appropriate number shown on the
back cover of this document.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING CAUSING SEVERE PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware and ALWAYS follow all installation instructions
provided with equipment.
IMPORTANT ! :
The combined height of projector and
interface bracket must not exceed 8 1/4" (210mm).
To install projector:
1. Assemble interface bracket to projector following the
instructions provided with the interface bracket.
2. Orient projector and position under lift cradle, aligning studs
on interface bracket with mounting holes in cradle.
x4
x4
Flange
Pan
Joists
Flange
Truss
Ceiling Tile
Flange on Lift Housing
Lift Housing
Lag or Cap Screw
or Drywall