CHIEF SLEU PROJECTOR LIFT, Руководство по эксплуатации

Страница: 16 / 21

Installation Instructions SLEU
9
3. Raise projector upward until studs on interface bracket are
through mounting holes in cradle, and secure projector to
lift using thumb nuts provided with the interface bracket.
Figure 11
Wiring the Lift and Cable Management
Wiring the Lift
WARNING:
ELECTRIC SHOCK AND FIRE HAZARD!
IMPROPER INSTALLATION OF WIRING CAN LEAD TO
SEVERE PERSONAL INJURY OR RISK OF FIRE! The
installation of this lift requires it be hard wired. ALWAYS have
wiring installed by a qualified electrician and follow all
electrical codes.
WARNING:
ELECTRIC SHOCK HAZARD! DO NOT
provide power to switch or energize circuit until lift has been
fully installed in ceiling and all connections have been made
and verified.
1. Remove cover from J-Box inside lift housing.
(See figure 12)
2. Disconnect wire extensions from wires inside J-Box by
turning wire nuts counterclockwise. Set wire nuts aside for
re-use. (See figure 12)
3. Install outlet for projector power in J-box if required.
(See figure 12)
Figure 12
4. Feed common wire from switch and projector power cable
through Strain relief and into lift housing. (See figure 13)
5. Feed common wire from switch and projector power cable
through Strain relief and into J-Box. (See figure 13)
6. Connect projector power to outlet if installed or to projector
following the projector manufacturers instructions.
7. Connect the common wire from switch to the blue
(common) wire from motor using wire nut.
Figure 13
Wire Nuts
Wire extensions (3)
(3)
J-Box
(Cover removed)
Projector Power Outlet
(Optional, not provided with lift)
Common Wire From Switch
Blue wire from Motor
Projector Power Cable
Common Wire From Switch