CHIEF MSP-WL10D, Руководство по установке

Страница: 13 / 24

Installation Instructions MSP-WLB/D SERIES
13
Flush Mounting Holes
1. Position faceplate in desired mounting position. Adjust as
required before proceeding. See Height Adjustment Section
for details.
2. Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (U3) into the
upper mounting
holes on the display. Thread screws completely into display,
then back out 3 complete turns. (See Figure 25)
Figure 25
3. Pick up and align display so that screws (U3) (installed on
the back of the display in the previous step) fit into the
mounting holes on the faceplate. Lower the display firmly
into place. (See Figure 25)
4.
Using Phillips screwdriver, install two M4x12 mm Phillips
pan machine screws (U3) through the
lower mounting holes
on faceplate into the display. (See Figure 26)
Figure 26
5. Tighten all four screws (U3). Do not over tighten!
NOTE:
If roll adjustment is desired for center faceplate, do not
tighten screws.
6. Repeat Steps 1-5 for other displays.
7. Proceed to Cable Management Section.
Recessed Mounting Holes
NOTE:
If faceplate does not fit into recessed area of display,
proceed with the steps in this section.
1. Determine depth of recessed mounting holes relative to
back surface of display (against which faceplate will
contact).
2. Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
3. Using Phillips screwdriver, carefully install two selected
screws (U1 or U2) through selected spacers (U4 or U5) into
the
upper mounting holes on the display. Thread screws
completely into display, then back out 3 complete turns.
(See Figure 27)
4. Pick up and align display so that screws (U1 or U2)
(installed on the back of the display in the previous step) fit
into the mounting holes on the faceplate. Lower the display
firmly into place. (See Figure 27)
Figure 27
Faceplate
(column not shown for clarity)
(U3) x 2
2
faceplate
(column not shown for clarity)
(U3) x 2
4
IF recess DEPTH is: THEN use spacer: AND screw:
3/8” or less U4 (3/8” long) U2 (M4 x 20mm)
More than 3/8” up to
and including 3/4” U5 (3/4” long) U1 (M4 x 30mm)
(U4 or U5) x 2
(U1 or U2) x 2 3
faceplate
(column not shown for clarity)
4