CHIEF MSP-WL10D, Руководство по установке

Страница: 19 / 24

Installation Instructions MSP-WLB/D SERIES
19
Pitch Adjustment (WL13D only)
1. Adjust pitch to desired tilt position. (See Figure 47)
2. Adjust pitch tension screw to change the adjustment
tension. (See Figure 47)
Pivot Adjustment (WL13D only)
3. Adjust pivot position as desired. (See Figure 47)
4. Use 3/16” hex key (DD) to adjust pivot point tension screws
to change pivot adjustment tension. (See Figure 47)
Figure 47
Rotational Adjustment (WL13D only)
NOTE:
(Optional) Rotational adjustment may be locked by
installing rotational locking screw (HH) into back of
faceplate. (See Figure 48)
Figure 48
5. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
47)
6. Use 3/16” hex key (DD) to adjust rotational adjustment
screw to adjust rotational tension. (See Figure 47)
Display Removal
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 49)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 49)
Figure 49
Display Removal Security Screw
NOTE:
In order to prevent display from being easily removed
from mount using the quick release lever, install
M4x4mm security screw (GG) into lower hole on back
of faceplate. (See Figure 50)
Figure 50
pitch
pivot point
tension
tension
5
1
3
Rotational tension
6
(HH)
quick release tab
2
(GG)