CHIEF MSP-WL10D, Руководство по установке

Страница: 12 / 24

MSP-WLB/D SERIES Installation Instructions
12
RECESSED MOUNTING HOLES
1. Carefully place display face down on protective surface.
2. Determine depth of recessed mounting holes relative to
back surface of display (against which Centris head will
contact).
3. Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
4. Place the four selected spacers over each of the mount
holes on the back of the display.
5. Pick up and orient the Centris bracket (C) so that the
mounting holes are aligned with the holes in the spacers;
rotate the Centris bracket as required. (See Figure 23)
Figure 23
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
6. Using Phillips screwdriver, install four selected screws (U2
or U3) through the mounting holes in Centris bracket,
through the spacers (U4 or U5), into the display. (See Figure
23) Tighten all four screws. Do not overtighten!
7. Return to Centris Head to Array section to complete
installation.
WL6B
Faceplate Positioning
IMPORTANT ! : Faceplates should be positioned prior to
attaching displays as the height cannot be adjusted with
the displays attached to the faceplates.
1. Loosen height adjustment screws for each faceplate to
adjust height. (See Figure 24)
2. Adjust display to desired height. (See Figure 24)
IMPORTANT ! : In order to install displays with no gap in
between displays, distance between faceplates must
equal the height of each display. (See Figure 24)
IMPORTANT ! :
Faceplates may be positioned a minimum of
12" apart and a maximum of 16" apart.
3. Tighten height adjustment screws to lock display’s position.
(See Figure 24)
Figure 24
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the WL6B mounts up to (and
including) the displays do not exceed 15 lbs (13.6 kg) per
display.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily thread into display
mounting holes.
NOTE:
Supplied screws (U1, U3 and U3) may not fit properly
for all displays. See display’s operating instructions for
details.
NOTE:
Set height of lower center display prior to installing
other displays. See Height Adjustment Section for
details. Center of display must be at least 18" above
desk surface.
IF recess DEPTH is: THEN use spacer: AND screw:
3/8” or less U4 (3/8” long) U2 (M4 x 20mm)
More than 3/8” up to
and including 3/4” U5 (3/4” long) U3 (M4 x 30mm)
(U1 or U2) x 4
(C)
(U3 or U4) x 4
2
2
1
3
1
3