Chevrolet 10 series 1973, Руководство по капитальному ремонту

Страница: 293 / 522

7 M - 7 4 CLUTCHES A N D M A N U A L T R A N S M IS S IO N S
S N A P
R IN G
Fig. 17F—Removing Rear O u tp ut Bearing R etaining
Ring
installed on transfer case so shim requirements may
be determined.
7. Install speedometer driven gear in case.
Front Output Shaft Bearing Retainer Seal
Replacement (Fig. 20F)
1. Pry or drive out existing seal from retainer bore.
2. Clean and inspect retainer.
3. Apply sealer to outer diameter of new seal.
4. Position seal to retainer bore and using Tool
J-22836 or equivalent, install seal in retainer.
Front Output Shaft Rear Bearing
Replacement
1. Remove rear cover from transfer case. Remove
gasket and discard.
2. Support rear cover and press bearing from cover.
3. Position new bearing to outside face of cover and
using a piece of wood to cover bearing, press
bearing into cover until flush with opening.
4. Position gasket and cover to transfer case and tap
into place.
5. Install cover retaining bolts and torque to
specifications.
ASSEMBLY OF TRANSFER CASE (FIGS. IF
AND 13F)
1. Place rnage box on blocks, with input gear side
toward bench (fig. 2 IF).
2. Position range box-to-transfer case housing gasket
on input housing.
Fig. 18F—Removing Rear O u tp ut S haft Front Bearing
Fig. 19F—In s ta llin g Rear O u tp u t Housing Seal
3. Install lockout clutch and drive sprocket assembly
on the input shaft assembly.
NOTE: A 2" band clamp may be installed on
end of shaft to prevent loosing bearings from
clutch assembly.
J— 22388
OVERHAUL MANUAL