Chevrolet 10 series 1973, Руководство по капитальному ремонту

Страница: 224 / 522

CLUTCHES A N D M A N U A L T R A N S M IS S I O N S 7 M - 5
Fig. 5E-R em oving Levers (Step 2)
very important that each group be arranged
in like sequence.
7. Assemble anti-rattle springs in cover (Fig. 9E). The
spring to the left is in operating position.
8. Lower the cover on top of the assembled parts, (fig.
10E) being sure that the anti-rattle springs are in
correct position and also that the punch marks
made before dismantling are matched to insure
retaining the original balance.
9. Place a bar across the cover and slowly compress,
guiding the holes in the cover over the pressure
plate lugs and all springs into their spring seats in
the cover.
Fig. 8 E -S p rin g A rran g e m e nt D iagram
10. Assemble adjusting nuts on the eyebolts and screw
them down until their tops are flush with the tops of
the eyebolts. Slowly release pressure of spindle and
remove cover assembly from press.
3 5 0 V -8
9 SPRINGS
PAINTED
ORANGE
ADJACENT
TO LEVERS
3 SPRINGS
UNPAINTED
3 SPRINGS
PAINTED
LIGHT GRAY
4 5 4 -V 8
9 SPRINGS
PAINTED
LIGHT BLUE
ADJACENT
TO LEVERS
Fig. 6E-G reasing Lug
Fig. 9E- In s ta llin g A n ti-R a ttle Spring
Fig. 7 E --lnsta lling Lever
ADJUSTING LEVERS
While no wear adjustment is needed because of the coil
spring design, it is imperative that the clutch release
levers are each set to exactly the same height at the time
of manufacture or rebuild to insure uniform clutch
application. To obtain exactly the same adjustment at
each release lever, use gauge plate J-1048 and release
lever height gauge J-6456 as follows:
1. Place gauge plate J-1048 (fig. HE) on the flywheel
in position normally occupied by driven plate.
NOTE: It is recommended that a spare
flywheel be obtained so that this operation
may be performed at the bench.
2. Bolt cover on flywheel with gauge plate center.
STRUT
EYEBO LT
R ELEA SE
LEVER
OVERHAUL MANUAL