Installation Guide for FibeAir IP-20C-HP
Page 10 of 204
Ceragon Proprietary and Confidential
1.
Before You Start
1.1
Important Notes
•
For the warranty to be honored, install the unit in accordance with the instructions in this manual.
•
Any changes or modifications of equipment not expressly approved by the manufacturer could
void the user’s authority to operate the equipment and the warranty for such equipment.
•
IP-20C-HP is intended for installation in a restricted access location.
•
IP-20C-HP must be installed and permanently connected to protective earth by qualified service
personnel in accordance with applicable national electrical codes.
1.2
Safety Precautions & Declared Material
1.2.1
Public and Occupational Boundary Distances Under Article 3.1(a) of the
RE Directive
Based on the highest nominal output power of the IP-20C-HP:
•
The public exposure of compliance boundary distance is 24.6m.
•
The occupational exposure of compliance boundary distance is 4.9m. This is the worst case for the
highest nominal output power, using antennas up to 3 ft. For all other configurations, the
compliance boundary distance is 0.
Note that even when the compliance boundary is a non-zero value, this only applies
within the bore sight of the antenna dish. Therefore, during work within and close to
the front of the antenna, make sure the transmitters are turned off. As long as the
transmitters are turned off during any work on the system, the occupational exposure
limit is not of concern to workers operating in or around the parabolic dish antenna.
1.2.2
General Equipment Precautions
To avoid malfunctioning or personnel injuries, equipment or
accessories/kits/plug-in unit installation, requires qualified and trained personnel.
Changes or modifications not expressly approved by Ceragon Networks could void the
user's authority to operate the equipment.
Where special cables, shields, adapters and grounding kits are supplied or
described in this manual, these items must be used, to comply with the FCC regulations.
Use of controls, adjustments, or performing procedures other than those
specified herein, may result in hazardous radiation exposure.
When working with an IP-20C-HP, note the following risk of electric shock and
energy hazard:
Disconnecting one power supply disconnects only one power supply module. To isolate
the unit completely, disconnect all power supplies.
