CEA DIGITECH vision PULSE 3000, Руководство оператора

Страница: 60 / 100

36
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Shows the value for the WIRE SPEED ( ).
PARAMETER SELECTION LED - A
The LED unit shows the WIRE SPEED ( ) switched on.
ENCODER K
NOB
- A
Adjusts the value for the WIRE SPEED ( ).
WIRE K
EY
Activates loading of the wire.
WELDING MODE SELECTION K
EY
Scrolls the various welding modes in succession.
WELDING MODE SELECTION LED The LED unit indicates the welding mode selected according to the VISION S
CREEN
.
PARAMETER DISPLAY S
CREEN
- V
Shows the parameter indicated by the
PARAMETER SELECTION LED - V
.
PARAMETER SELECTION LED - V
The LED unit indicates the welding parameter selected using the
PARAMETER SELECTION K
EY
- V
.
PARAMETER SELECTION K
EY
- V
Scrolls in succession WELDING VOLTAGE ( ) - ELECTRONIC INDUCTANCE ( ).
ENCODER K
NOB
- V
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- V
.
GAS K
EY
Activates the flow of gas.
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT4 panel and not on the DH panel.
4 - WELDING MIG-MAG manual
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
m/min
V
7.8 31.3
MENU K
EY
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
SX K
EY
Scrolls in succession WELDING CURRENT ( ) - WIRE SPEED ( ) only on the
VISION
S
CREEN
.
In this case, where possible, the values displayed will be those measured.
When welding is in progress the WELDING CURRENT ( ) is displayed continuously until
this key is pushed.
(continued)