CEA DIGITECH vision PULSE 3000, Руководство оператора

Страница: 59 / 100

35
Special function
PARAMETER DISPLAY
Screen - A
PARAMETER DISPLAY Screen - V Welding mode
Default Range TWO STROKE (2T) FOUR STROKE (4T) CRA
TER 2T
CRA
TER 4T
SPOT WELDING STITCH WELDING CYCLE ST
ANDARD
CYCLE ADV
ANCED
FINAL CRATER TIME F15 0.0s (0.0 - 5.0)s ●
BURN BACK bub 0 -30 - +30 ● ● ● ● ● ● ● ●
POST GAS PoG 1.0s (0.0 - 10.0)s ● ● ● ● ● ● ● ●
FIRST SLOPE ( I
1
TO I
2
) F18 0.05s (0.0 - 1.0)s ●
CYCLE WIRE SPEED
F19 5.0m/min (0.6 - MAX)m/min ● ●
CYCLE VOLTAGE
F20 25.0V (min - MAX)V ● ●
SECOND SLOPE ( I
2
TO I
1
) F21 0.05s (0.0 - 1.0)s ●
ACS / ENCODER SPEED F28 100A/s (5 - 500)A/s ● ● ● ● ● ● ● ●
WARNING:
• The STANDARD or ADVANCED welding CYCLE mode can only be activated by opening the ADVANCED SETUP Menu - AD-
VANCED MODE - CYCLE (for further explanations, see the relevant paragraph).
• It is possible to access editing of the SPECIAL FUNCTIONS (Fx) during welding.
• Some of the values edited will be used immediately by the operator, while others will be active from when the next welding
task begins.
• The HOLD function is not active within the SPECIAL FUNCTIONS Menu (SET UP Fx) .
3 - PRE-SETTING MIG-MAG manual
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
m/min
V
7.8 31.3
MENU K
EY
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
ENCODER K
NOB
- SX Adjusts the parameter selected using the SX K
EY
.
DX K
EY
Scrolls in succession WELDING VOLTAGE ( ) - ELECTRONIC INDUCTANCE ( ) only on
VISION S
CREEN
(this operation is activated when the key is released).
ENCODER K
NOB
- DX Adjusts the parameter selected using the DX K
EY
.