Castolin Eutectic totalarc2 3000, Руководство по эксплуатации, Страница: 48 / 161

48
- Briefly press down the MEM button to change to the job
menu. The first vacant program location for the Job is
indicated.
- Select the desired program location with the Program but-
ton , or else leave the suggested program location unchan-
ged
- Use Program button to select which job you want to copy
- Press down and hold the MEM button . The job is copied
to the program location you have just selected.
N.B.! If the selected program location already has a job stored
in it, then this existing job will be overwritten with the new job.
This action cannot be undone.
“PrG” appears on the left-hand display to indicate that the job
is now stored. Release the MEM button .
- Briefly press down the MEM button to exit from the job
menu
Job mode
The “Job Mode” enhances the quality of welding-engineering
fabrication, both in manual welding and also in semi-automatic
and fully automated operation.
The traditional way of reproducing often-needed jobs (opera-
ting points) has been to document the required parameters by
hand. In Job Mode, it is now possible to create, copy, delete and
retrieve up to 50 different jobs (only MIG/MAG welding pro-
cess).
The following syntax is used in Job Mode on the left-hand
indicator:
- - - ... No job in this program location (only when you try to
retrieve a job from this location, otherwise nPG)
nPG .. No job in this program location
PrG ... There is a job in this program location
dEL ... Job is being deleted from this program location
Pro ... Display of the welding program ("characteristic") in which
the job is created
Creating a Job
The machine comes with no jobs pre-programmed. Before you
can retrieve a job, then, this job has to be created first. To create
a job, proceed as follows:
- Set the desired welding parameters that you want to store as
a “Job”
5 . 5 2 4 . 6
2 6
- Briefly press down the MEM button to change to the job
menu. The first vacant program location for the Job is
indicated.
- Select the desired program location with the program but-ton
, or else leave the suggested program location unchanged
- Press down and hold MEM button
N.B.! If the selected program location already has a job stored
in it, then this existing job will be overwritten with the new job.
This action cannot be undone.
“PrG” appears on the left-hand display to indicate that the job
is now stored. Release the MEM button .
N P G 0
N P G 1
N.B! All the parameters of the set-up menu are also automa-
tically stored along with every job - except for the functions
“PushPull Unit”, “Cooling-unit cut-out”.
Copy / overwrite Job
You can copy a job that has already been stored in one program
location to any other program location. To copy a job, proceed
as described below:
- With the Process button , select MIG/MAG welding
- With the MIG/MAG mode button
, select MIG/MAG job
mode (MEM)
P R G
1
5 . 5
2 4 . 6 2 6
5 . 5 2 4 . 6 1
3 . 8 2 0 . 7 2
N P G
0
N P G 3