Casio SA-400, Руководство пользователя

Страница: 22 / 29

42 43
To perform a system update:
1.
Press
PROGRAM
.
2.
3.
4.
ADDITIONAL INFORMATION
When a system update is performed, it updates the status of all the stations in the system. A
system update should be performed when removing a station from the system.
PERFORMING A SYSTEM UPDATE
PLEASE SELECT
PHON TIME OTHER
CALLER ID
BACK ENTER NEXT
SET STATION ID
BACK ENTER NEXT
5.
“
UPDATING NOW
” will appear in the
display.
6.
When the update has completed,
“
FINISHED
” will appear in the display.
7.
Press
PROGRAM
to exit.
SYSTEM UPDATE
BACK YES NO
If line conditions cause communication errors between station, units may need to be reset as a
remedy. A reset will not erase any stored data.
To reset a station,
1.
Take the tip of a pen and insert it into the small opening on the back of the unit labeled
“RESET.”
2.
You will hear a click and the display and station LEDs will briefly turn off and then back on.
All data and system information will be retained and network communication will be restored.
STATION RESET
ADDITIONAL INFORMATION
POWER FAILURE OPERATION
The SA-400 does not require a battery during a power failure to maintain programmed
information and caller ID records. During a power failure without the battery, the time and day
will be erased after an hour.
For basic telephone operation on line 1 during power failure, install four AA Alkaline batteries.
Call privacy is not guarded during power failure telephone calls.
PERMANENT MEMORY PROTECTION
Programmed information such as caller ID records, autodial entries and station ID are all stored
on the SA-400’s memory indefinitely, or until you choose to completely reset the system.
SHORT TERM MEMORY
In a power failure, the time and date setting will be maintained for up to 1 hour, if batteries are
installed. See below for “BATTERY INSTALLATION.”
Function Power Failure with Batteries Power Failure without Batteries
Line 1(only) Operates Will not operate
Line Status Indication Operates Will not operate
Handset Use Operates Will not operate
Flash Operates Will not operate
Install four AA alkaline batteries (not included) into the bottom side of the SA-400 base to enable
the telephone to operate up to 1 hours during a power failure. Batteries are not necessary for the
SA-400 to operate and retain stored data with AC power.
1.
Turn the SA-400 over and remove the mounting pedestal if attached.
2.
Remove the battery cover.
3.
Install four AA alkaline batteries. Make sure the ribbon lies under the batteries and the
batteries are in the correct directions.
4.
Replace the cover.
BATTERY INSTALLATION
ADDITIONAL INFO
ADDITIONAL INFO