CASE CONSTRUCTION CX75C SR, Руководство оператора

Страница: 64 / 256

3 - CONTROLS/INSTRUMENTS
The hour meter displays the engine operation time in
units of
0.1 h ( 6 min )
14. Fuel economy display. The time/fuel consumption at
that time “L/hr” is displayed.
15. Message screens
SMIL13CEX2599AB
3
This section of the display screen shows information
icons and messages that change according to the set
application of the machine.
An alarm also sounds when some of these messages
are displayed.
The following section describes the icons, mes-
sages, and their corresponding explanations.
NOTICE: If a message is displayed, perform mainte-
nance according to the message.
NOTICE: If the message is still displayed after
maintenance, consult your CASE CONSTRUCTION
Dealer.
NOTE: The language of the displayed messages can
be changed, consult your CASE CONSTRUCTION
Dealer.
• Low oil pressure
Indicates that the engine oil level is low.
An alarm sounds. Stop the engine and re-
move the ignition key, and then inspect the
oil level.
NOTE: If the measures above are not performed im-
mediately when this message is displayed, the engine
stops automatically.
• Over heat
Indicates that the engine coolant tempera-
ture is high. An alarm sounds. Lower the
engine speed. If the temperature does not
go down, stop the engine and remove the
ignition key. Wait for the temperature of the
cooling system to go down, and then in-
spect the coolant level inside the reservoir
tank and radiator. Check the radiator and oil
cooler. (Refer to page
6-50 ).
• Boost temp high
Indicates that the temperature of the tur-
bocharger air that is being supplied to
the engine is abnormally high.
An alarm
sounds. The engine automatically enters
idling mode as a preventative measure.
Stop the machine, operate the engine at
idling speed, and wait until the message
disappears. If the turbocharger air tempera-
ture on the display screen continues to rise,
the engine stops automatically.
Consult
your CASE CONSTRUCTION Dealer.
• Alternator
Indicates that there is a problem in the al-
ternator. An alarm sounds. Stop the en-
gine and remove the ignition key, and then
inspect the alternator. Consult your CASE
CONSTRUCTION Dealer.
• Check engine
Indicates that there is a problem (short or
disconnection) in the electrical system of the
engine. An alarm sounds. Stop the engine
and remove the ignition key, and then in-
spect the electrical system. Consult your
CASE CONSTRUCTION Dealer.
• Elec. problem
Indicates that there is a problem in the elec-
trical system. An alarm sounds. In this case,
stop the engine and remove the ignition key,
and then investigate the cause or consult
your CASE CONSTRUCTION Dealer.
• Engine stop
Indicates that the emergency stop switch
operated. An alarm sounds. To enable the
engine to be started again, the switch must
be canceled.
• Improper shut down
Perform low idling for at least 5 min before
stopping the engine.
• Check camera
Indicates that there is a problem (short or
disconnection) in the monitor camera con-
nection.
• Over load
The load is excessive. Reduce the load.
• Low coolant
3-16