3 - CONTROLS/INSTRUMENTS
Headrest adjustment section
Press the lock switch
(5)
on top of the seat backrest to
adjust the headrest up and down.
SMIL13CEX2574AB
6
Seatback angle adjustment section
To adjust the angle of the backrest, pull up the lever
(6)
.
Move the backrest to the desired position, then release
the lever
(6)
.
SMIL13CEX2575AB
7
Seat belt
Sit on the operator's seat in a comfortable posture, pull
out the belt
(7)
, then insert it into the buckle
(8)
.
NOTE:
if the pulled-out portion of the belt is too short, let
the seat belt go. After the belt is rewound, pull it out again.
To undo the seat belt, press the release lever
(8)
.
WARNING
Equipment failure could cause accident or in-
jury!
Always fasten seat belt securely before op-
erating the machine. Inspect seat belt parts
for wear and/or damage. To ensure operator
safety, replace any and all damaged parts of
the seat belt prior to operation.
Failure to comply could result in death or se-
rious injury.
W0046A
NOTE:
inspect the seat belt. Check that the seat belt is
not damaged and all the installation screws are securely
tightened. Replace any parts with problems.
Always keep the seat belt clean. Use only soap and water
to clean the seat belt. Do not use bleach or dye.
SMIL13CEX2576AB
8
3-5
Содержание CX75C SR
