CASE CONSTRUCTION CX75C SR, Руководство оператора

Страница: 63 / 256

3 - CONTROLS/INSTRUMENTS
1. Engine coolant temperature gauge
Displays the temperature of the engine coolant.
The lower zone indicates that the engine coolant tem-
perature is low.
When the temperature gauge display reaches the up-
per zone, an alarm sounds and "Over heat" is dis-
played (see "Message screens").
Lower the engine speed.
If the temperature does not go down, stop the engine,
remove the ignition key, and investigate the cause.
2. Hydraulic oil temperature gauge
Displays the temperature of the hydraulic oil.
The lower zone indicates that the hydraulic oil tem-
perature is low.
When the temperature gauge display reaches the up-
per zone, an alarm sounds and "Over heat" is dis-
played (see "Message screens").
Lower the engine speed.
If the temperature does not go down, stop the engine,
remove the ignition key, and investigate the cause.
3. Fuel gauge
Displays the remaining amount of fuel by the number
of lit segments.
When all are lit, it indicates that the fuel tank is full.
When only 1 is lit, an alarm sounds and "Low fuel" is
displayed (see "Message screens").
NOTE: It is not necessary to wait until the fuel tank
is empty before filling with fuel. If the tank becomes
empty, air bleeding of the fuel system is required.
4. Work mode icon
These indicators display the initial work mode and the
engine speed that was selected with the engine ac-
celeration button and work mode selector. (Refer to
page
Console Right-hand console - Control iden-
tification ).
5. Travel mode icon
At low speed, is displayed.
At high speed, is displayed.
6. Working light
Displayed when the light is on.
7. Engine auto idling and stop selection display
Displayed when auto idling is selected.
“Auto n/min”.
Displayed when auto stop is selected.
“Auto idle stop”.
Displayed when auto idling and
auto stop are selected.
“Auto
n/min” and “Auto idle stop”.
8. Anti-theft protection
Displayed when the anti-theft protection
function is operating.
9. Displays the selected attachment
Hydraulic breaker
Crusher grapple
10. Clock display (Refer to page 3-25
11. Eco gauge
The number of indicators on this gauge increases
when the operating state is energy-saving operation.
If high-load operations are performed, the number of
gauge indicators decreases.
The state of energy-saving operations is indicated.
• No mechanical abnormalities will occur even if the
number of gauge indicators decreases. However, to
help conserve the environment, try to perform en-
ergy-saving operations within the green range, so
long as doing so does not hinder work.
Key points for energy-saving operations
• Try to use
H mode or A mode instead of SP mode.
• Avoid sharp lever operations.
• Avoid high load and relief operations.
• Use auto idle and one-touch idle.
Also, use idle stop to stop unnecessary idling.
Ask your CASE CONSTRUCTION Dealer about how
to turn the eco gauge display
“On” and “Off” .
12. Mute icon
Displayed when the radio volume is
muted.
13. Hour meter
3-15