Case Communications syncro 1496, Справочное руководство

Страница: 107 / 192

/CO
Cable equaliser disabled.
/C1 Cable equaliser enabled. Default.
The equaliser should normally be enabled for all modes. It should
only be disabled if both the local and remote modems are attached
to the same PABX.
D Dial a Number
This command is used to dial a specified telephone number with, if
required, special instructions (known as modifiers).
Dnn
where
nn
is the telephone number
To dial a number with no modifiers, enter the number you want to
dial immediately after the command, e.g.
ATD0123456789 .
To dial a number with modifiers, select the required modifiers from
the list below, and incorporate them in the dialling sequence as
instructed.
An example of a number with modifiers would be to dial through a
PABX where the prefix to an outside line is 9, and a pause is needed
before the number, e.g.
ATD9,0123456789
.
Dialling Modifiers
P Pulse Dial
T
Tone Dial
These modifiers select pulse or tone dialling. They can be
inserted at any required point in the dialling string, which is
useful where switchboards use a different prefix dialling mode.
ATDP nn where nn is the telephone number.
ATDT nn
where
nn
is the telephone number.
ATDP p T nn where p is the prefix and nn is the
telephone number.
The modem will stay in the set P or T mode for future dialling
until the alternative modifier is selected.
,
Pause Before Dialling
A comma will cause the modem to pause for the period of time
set in S-register S8, for example after a prefix, before
X450-310851 Issue 2 8-5 Rev.0