Case Communications syncro 1496, Справочное руководство

Страница: 64 / 192

4.4 Manipulating Modem Configurations
The method of loading a factory or user configuration from the front panel
was described in Section 4.3. This section describes how to ''recall'' and
''save'' configurations by the following commands.
&Fn Recall factory configuration
Zn Recall user configuration
&Wn
Save user configuration
*C
Display active configuration
A diagrammatic representation of the configurations and commands is
given in Figure 4-1.
Figure 4-1 Modem Software Configurations
Zn &Wn &Fn
ACTIVE
CONFIGURATION
FACTORY
CONFIGURATIONS
(0-11)
USER
CONFIGURATIONS
(0-3)
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a
Command
Terminal
a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a
View Config: *C
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
MODEM
The ''active'' configuration is the one in operation. It is accessible from the
command terminal. The active configuration is automatically retained in
non-volatile memory when the modem is switched off.
You can recall a configuration (factory or user) from memory to become the
active configuration. You can then change and save the active
configuration to become a user configuration (0-3) in memory.
The relevant commands are summarised in Table 4-2.
Examples of displays obtainable by the
*C
command were given in Section
4.1.3.
X450-310851 Issue 2 4-28 Rev.0