Case Communications syncro 1496, Справочное руководство

Страница: 80 / 192

3. Press and release the
ENTER
button. The stored number will now be
dialled.
4. Release all the other buttons.
6.2.2 Manual Dialling by Attached Telephone
This procedure requires a telephone to be connected to your modem (see the
Appendix entitled 'Technical Guide').
1. Dial the required number as normal.
2. When you hear answer tone from the remote modem, press the
DATA
button on your modem's front panel.
3. Replace the handset on-hook.
4. The call will clear down when you press the
DATA
button.
6.2.3 Autodialling by DTR
The autodial by DTR facility works as follows:
1. The DTR command (
&Q
) must be set to
&Q2
for synchronous operation.
2. The DTE must control the DTR line, raising it to request a connection.
3. When the modem detects that the DTR line has been raised, it connects
to the telephone line and dials the number stored in memory location
N0.
4. To terminate the call, the DTE must drop DTR. This causes the modem
to disconnect.
Note that the modem will also disconnect if the remote modem disconnects.
You can terminate the call by issuing an
H command.
6.2.4 Dialling by Command
When using the D command to dial a number, you can incorporate any of
the following modifiers:
P
Pulse dial the following number(s).
T
Tone dial the following number(s).
, Pause before continuing to dial.
W Wait for a dial tone.
!
Flash break.
X450-310851 Issue 2 6-4 Rev.0