Carver 38 super sport, Руководство пользователя

Страница: 137 / 162

3827 8/04
W
INTERIZATION AND
S
TORAGE
S
ECTION
8
2. Turn the “house” battery master disconnect switch to the “ON”
position.
3. On the Safety Breaker Panel, verify that the Auto Sump circuit
breaker is “ON.”
4. On the DC Control Center, switch the DC Main circuit breaker
“ON,” then switch the Pressure Water Pump circuit breaker “ON.”
5. Open all sink and shower faucets on the boat, including the faucets
for the optional transom hand shower and bow and transom fresh
water washdowns.
6. When there is no more water coming from any of the sink taps,
shower heads, or fresh water washdowns, switch the Pressure Water
Pump circuit breaker “OFF.”
7. Drain the water heater. Refer to the OEM information for details on
draining the water heater.
8.3.4.2 Winterizing the System
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s fresh water system. Using the wrong type of antifreeze can dam-
age the fresh water system. The repair of such damage is not included
under the terms of the Carver Limited Warranty.
1. Pour 25 gallons of nontoxic recreational vehicle antifreeze into your
boat’s fresh water tank.
NOTE: If the fresh water system loses pressure during this procedure,
you will have to add more antifreeze into the water tank.
2. Close all faucets.
3. On the DC Control Center, switch the Pressure Water Pump circuit
breaker “ON.”
4. If your boat does not have the optional grey water holding system,
place a large bucket under the sump discharge fitting, head sink
drain fitting, and galley sink drain fitting. This catches the anti-
freeze pumped out in the next step. Refer to 9.7.3 Thru-Hull Fit-
tings for the exact location of these fittings.
5. Open the galley sink cold water faucet. When a steady stream of
antifreeze flows from the tap, close the faucet. Repeat this step for
the galley hot water faucet, then for each cold and hot water faucet