Carrier TruVu VAVB3-E2, Руководство по установке и запуску

Страница: 82 / 155

Adjusting the TV-VAVB3-E2 driver properties
TruVu™ VAVB3 -E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
76
BACnet COV Throttling
Enable COV Throttling Under normal circumstances, COV Throttling should be enabled to prevent
excessive network traffic if an object's COV Increment is set too low. See
EXCEPTION below.
When enabled, if an object generates excessive COV broadcasts (5 updates in 3
seconds), the driver automatically throttles the broadcasts to 1 per second. Also,
if the object's value updates excessively for 30 seconds, an alarm is sent to the i-
Vu® application listing all objects that are updating excessively. A Return-to-
normal alarm is sent only after all objects have stopped updating excessively.
EXCEPTION: In rare circumstances, such as process control, a subscribing object
may require COV updates more frequently than once per second. For these
situations, clear this checkbox, but make sure that your network can support the
increased traffic. You will also need to disable the
Excessive COV alarms under
the driver's Common Alarms .
Trend Sampling
Collect a daily midnight
sample for all points in this
controller that are sampling
on COV For values that change infrequently, select to verify at midnight daily that the
point is still able to communicate trend values.
Local Network Configuration
Allow Local Network
Configuration from other
devices on the local network
for 24 hours You can unlock a controller for 24 hours to make IP address changes.
Locator LED
Blink Click the Blink button to prompt the Locator LED to flash for 15 seconds, allowing
you to verify the controller's physical location. After flashing, whenever the
actuator moves, the LED rotates in the same direction. LED rotation is
automatically disabled after 1 hour and can be re-enabled by pressing the
Blink
button again.
Debug
Enable Debug Messages Enable only if directed by Carrier Control Systems Support.