Carrier TruVu VAVB3-E2, Руководство по установке и запуску

Страница: 107 / 155

Troubleshooting
TruVu™ VAVB3 -E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
101
To configure custom Prog 1/2 LEDs
You can customize the Prog 1 and/or Prog 2 LED for site-specific purposes by configuring the BACnet Analog
Output (BAO) microblock.
Open your control program in the Snap interface, select the AO microblock for each LED, and use the following
settings:
Status/Attribute Microblock
type Expander number :
Channel number I/O type Description
LED 1 BAO 0:61 Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
LED 2 BAO 0:62 Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
To get a Module Status report
A Module Status report provides information about the controller and verifies proper network communication with
the controller. You can get this report:
•
In the i-Vu® application — Right-click the controller on the navigation tree, then select Module Status .
•
In the Field Assistant application — Right-click the controller in the navigation tree and select Module Status .
•
On the controller setup ModStat tab — See To set up the controller through the Service Port (page 88).
See Module Status field descriptions (page 145) in the Appendix.