© 2014, Carmanah Technologies Corporation. June 2014. 61249_M650H_User_Manual_RevC
M650H USER MANUAL
57
Appendix B: Using
the Infrared Remote
Programmer
The (optional) Infrared Remote Programmer
(IR Remote) allows you to access a subset of the
M650H functions. This is useful if the lantern is bolted
down, preventing access to the On-Board User
Interface (OBUI) or the USB connector.
NOTE
The IR Remote uses the following
codes:
User Passcode = 753
Off = 000
Ship Mode = 820
Out of Ship Mode = 821
Batt Check = 810
NOTE
The IR Passcodes (User and Dis-
tributor) are the same ones used
to login using the OBUI. They can
be changed using the 650 Device
Manager software.
NOTE
If the "Can Change Flash Code"
checkbox is cleared in the 650DM,
the Flash Code will not be editable
when logged in to the M650H
using the User passcode. (The
Flash Code can always be edited
by logging in with the Distributor
Passcode.)
NOTE
If the M650H is a switched model,
it won't respond to IR commands
unless the switch is in the On
position.
You can perform the following functions with the IR
Remote:
• Check the Battery Pack Health
• Change the Flash Code
• Put the M650H into
Ship Mode
• Retrieve the M650H from
Ship Mode
• Enter
Off Mode
Entering the Passcode
You must enter a Passcode before you can access
any of the IR Remote features.
To enter the Passcode:
1. Point the IR Remote at the side of the M650H.
2. Press and hold any button for approximately three
seconds. The right-most decimal point on the
OBUI illuminates steadily to indicate it received
the IR signal and entered IR Edit Mode. In IR Edit
Mode, the main LED inside the lens will flash in
response to every button press or the IR remote.
3. Press the
Start
button on the IR Remote. The
OBUI displays "
I r Pr
" briefly to indicate that it has
received the IR signal.
4. Enter the Passcode using the IR Remote. The
default Passcode is
753
. Each time you enter one
of the digits for the Passcode, the OBUI flashes "lr
X" (where X indicates the button you pressed on
the IR Remote. For example, if you press the up
button on the IR Remote, the display reads "I r U
P"; "I r 0 9" displays when you press the 9 button;
etc.).
5. Press the
Enter
button on the IR Remote.
6. After you successfully enter the Passcode, if the
main LED was on, it extinguishes and then flashes
three times quickly to indicate that the Passcode
entry was successful. If the Passcode entry was
unsuccessful, the main LED stays lit. This is a
security feature to prevent unauthorized persons
from interrupting the main LED during operation.
Repeat this procedure to enter the Passcode.
