CareFusion Alaris 8110 series, Руководство по обслуживанию

Страница: 111 / 172

TROUBLESHOOTING
6-5
Alaris
®
Syringe Module (8110 Series)
Alaris
®
PCA Module (8120 Series)
Technical Service Manual
Syringe Drive-Head Error 1. Syringe plunger travel impeded.
2. Cam Lock stripped or not engaged.
1. Remove drivetrain blockage. If
necessary, repair or replace Lower
Housing/Carriage Assembly.
2. Rotate Actuator Knob and slide
plunger head up and down, to check
for full plunger head travel and Cam
Lock engagement and
disengagement. If necessary, repair
or replace Lower Housing/Carriage
Assembly.
3. Return to factory.
Table 6-1. Technical Troubleshooting Guide
(Continued)
Message Probable Cause Remedy
Syringe Empty 1. If syringe is not empty, Force Sensor
Board Assembly is defective.
2. Syringe plunger travel impeded.
1. Use Maintenance Software to
perform Binary Switches Test.
Replace Force Sensor Assembly or
Linear Sensor if necessary.
€
2. Rotate Actuator Knob and slide
plunger head up and down, to check
for full plunger head travel and Cam
Lock engagement and
disengagement. Repair or replace
Lower Housing/Carriage Assembly if
necessary.
3. Return to factory.
Syringe Not Recognized 1. Odd size or wrong brand syringe
installed.
2. Syringe Size Sensor defective.
3. Logic Board software problem.
1. Replace syringe with a compatible
syringe (refer to Alaris
®
System
DFU
).
2. Use Maintenance Software to
perform Binary Switches Test.
Replace Syringe Size Sensor
Assembly if necessary.
3. Replace Logic Board and flash with
appropriate software version.
€
4. Return to factory.
€
Replacing the Force Sensor Assembly or Logic Board Assembly in a module with version
7
or earlier software
must be performed at the depot. Refer to the note at the beginning of this chapter for further information.