Carefree FREEDOM FREESTYLE WM, Руководство по обслуживанию

Страница: 14 / 24

F
REEDOM
F
REESTYLE
WM Service Manual Carefree of Colorado
10 052573-301r8
M
IDDLE
A
RM
R
EPLACEMENT
CAUTION
The spring arm is under tension to open. Use extreme care and firmly hold the
spring arms during assembly and disassembly to avoid any sudden or unexpected movement by
the arm. Serious personal injury and/or property damage could occur.
NOTICE
The middle spring arm is different than the outer arms. Center arms can be identified
by the blue dot located on or near the case connector of the arm. Do not use center arms for
replacing outer arms; do not use outer arms to replace the center arm.
Tools Required: Flat blade screwdriver (1/4"), needle nose pliers, regular pliers and/or e-ring tool. New e-clips
are included with the replacement arm.
Special Note: Carry the necessary tools, ties or sleeves and new e-clips. These must readily available during the
procedure.
21. Open the awning 2 to 3 feet.
22. Disconnect power to the awning.
23. At the lead rail, firmly hold the spring arm and remove the
clip and pin that secures the arm to the lead rail connector.
Set pin aside to be reused.
24. Fold the arm and secure using a large zip tie or cord. Do not
use bungee cords.
25. Loosen the pitch adjustment set screws.
26. Remove the retaining clip from the case connector.
27. Remove the arm from the awning and set aside.
CAUTION
When the arm is closed, it can open with significant force. Use care when
opening the arm.
28. Lift the arm assembly into position and slide the pivot assembly into the case connector.
29. Secure the pivot assembly to the case connector with a new retaining clip (large).
30. Firmly hold the new arm assembly and remove the shipping ties. Allow the arm to open slowly.
31. Slide the arm onto the lead rail connector and secure using the pin removed previously and a new clip
(small).
NOTE: When aligning the pin through the arm and lead rail connector, it may be necessary to pivot the
lead rail. The lead rail is made to pivot on the lead rail connectors.
32. Tighten the lower pitch adjustment screw until snug.
33. Tighten the upper pitch adjustment screw.
FF013a
Pitch Adjustment Screws Retaining Clip
Set Screw
Pin
Pivot Assy
Pivot Assy
Lead Rail Connector
Pin
Clip
Arm
WM036