Carefree FREEDOM FREESTYLE WM, Руководство по обслуживанию

Страница: 7 / 24

Carefree of Colorado Service Manual F
REEDOM
F
REESTYLE
WM
052573-301r8 3
9. Slide the black polycord of the fabric into the fabric slot. Orient the fabric with the hem on the top (the
hem will then roll against the roller tube). Center the fabric in the roller tube.
10. After the fabric is centered, on the RH end plug, pull and hold the excess polycord to one side of the fabric slot.
Place one (1) #10 x 2 PHSD screw through the fabric slot hole and polycord. The screw must be positioned to
thread into the metal of the roller tube slot and the edge of the polycord. The screw action will pull the polycord
further into the slot hole. D
O NOT OVERTIGHTEN
, maximum torque 16 in-lbs.
11. After the screw is installed, trim the excess polycord.
12. Roll the fabric onto the roller tube. Note the direction of the wrap as shown. The view is of the RH plug. Allow
adequate fabric to extend past the roller tube to cover the distance to the lead rail..
13. Slide the fabric into the lead rail and the roller tube into the case.
14. Align the roller tube with the motor drive and bearing. Press the roller tube into the case.
15. Align the RH end cap with the roller tube and case and attach using the screws and spacer removed
previously. Torque screws 15 in-lbs.
16. On the motor side, align the fabric slot of the roller tube and the access slot through the inner end cap.
17. Attach the fabric retaining screw through the motor bearing and into the roller tube.
18. Open and close the awning to confirm that the fabric rolls and unrolls squarely. Adjust the fabric
position in the lead rail as required.
19. Center the fabric in the lead rail. Trim any excess polycord flush with the inside of the lead rail end plates.
20. Attach the RH end plate and the fabric retaining screws (both ends).
NOTE: The top screw secures the fabric in the lead rail. The screw should be positioned to thread into
the metal of the lead rail and the edge of the polycord.
21. Reattach the outer end cap on the LH side. Torque screws to 15 in-lbs.
22. After installing the canopy, it may be necessary to adjust the motor limits for motorized awnings. Refer
to "Adjusting the Motor Limits" on page 13.