Carefree FREEDOM FREESTYLE WM, Руководство по обслуживанию

Страница: 12 / 24

F
REEDOM
F
REESTYLE
WM Service Manual Carefree of Colorado
8 052573-301r8
Removing a Configuration 2 Connector
This procedure does not require removing the end caps.
1. Open the awning until the arms are fully extended.
2. Disconnect power to the awning.
3. Remove the cable from the wire channel inside the case and on top of arm. Allow the harness to hang loosely.
NOTICE
It is necessary to hold and support the lead rail and arm during the removal and assembly
procedures to prevent damage to the awning.
4. At the case connector, remove the retaining
clip and slide the pivot assembly out of the
housing.
5. In the case, mark the location of the inside
edge of the connector housing,
DO NOT
mark the edge of the plate.
6. Loosen the clamping screw.
7. Slide the wedge out of the housing and the
case.
8. Remove the three (3) screws at the top of
the plate.
9. Slide the plate out of the upper groove of
the case.
Mark Location of the
Inside Edge of Housing
Slide Plate Out
of Upper Groove
Slide Wedge Out of
Case and Housing
Loosen
Clamping Screw
Pivot Assy Retaining Clip
Cable Channel
Remove Screws (x3)
Wedge (ref)
Housing (ref)
FF024