Carefree FREEDOM FREESTYLE WM, Руководство по обслуживанию

Страница: 6 / 24

F
REEDOM
F
REESTYLE
WM Service Manual Carefree of Colorado
2 052573-301r8
C
ANOPY
R
EPLACEMENT
This procedure requires two people.
1. Open the awning 18"-24".
2. Disconnect power to the awning.
3. Carefully push the lead rail toward the case so that the arms collapse and
the fabric is slack. While holding the lead rail in this position, firmly tie the
elbows of the spring arms together. Use a minimum 1/2" rope - do not use
bungee cords. When tying the rope, use a non-slip knot such as a square
knot or equivalent.
CAUTION
Failure to secure the lead rail as described
will allow the spring arms to extend out possibly causing personal injury and damage to the
awning.
1. Remove the two (2) screws holding the outer end cap. Set the cap and screws aside.
2. On the motor side, remove the fabric retaining screw. It may be necessary to rotate the roller tube to align the
screw with the access hole in the inner cap.
3. Remove the fabric retaining screw from the left lead rail end plate.
4. Remove the RH lead rail end plate and the RH end cap.
5. Slide the roller tube and fabric out of the case and lead rail.
6. Remove the fabric retaining screw located through the RH end plug.
7. Unroll the old fabric and slide off the roller tube.
8. Unfold the replacement fabric.
NOTICE
While the awning fabric is fairly robust, care must be taken not to snag it while sliding
the new fabric into the roller tube or lead rail.
Tip: Lightly spraying the slots with a dry silicone lubricant will help the fabric slide into the slot without
staining the material.
WM024a
Outer
End Cap
Fabric Retaining Screws
12-16 in-lbs.
RH End Plate
RH End Cap
Inner
End Cap
15 in-lbs.
Hem Rolls
Against Roller Tube
Pull and Hold
Polycord While
Placing Screw
View of RH (Idler) Plug
#10 x 2
Screw
Marquee012
Spring Arms
Firmly Tie
Elbows Together