Carefree FREEDOM FREESTYLE WM, Руководство по обслуживанию

Страница: 16 / 24

F
REEDOM
F
REESTYLE
WM Service Manual Carefree of Colorado
12 052573-301r8
I
NSTALL THE
N
EW
M
OTOR
1. Check that the one-way drive is installed on the new motor assembly with the "B" pointing toward the motor.
NOTICE
The one-way drive must be oriented with the "B" facing the motor. If the drive is
not oriented correctly, the awning will not operate and the arms will spring out when released.
2. Align the one-way drive with the roller tube and start sliding the new motor into the roller tube.
3. Align the bearing on the motor and slide into the roller tube.
4. Attach the fabric retaining screw through the bearing and in the fabric slot. The screw must be positioned to
thread into the metal of the roller tube slot and the edge of the polycord. It may be necessary to rotate the
roller tube to align the access hole and fabric slot.
5. Align the inner end cap with the roller tube and motor. Ensure that the large spacer is positioned in the inner
endcap.
6. Route the motor wires and harness connectors through hole in the endcap.
7. Align the screw holes in the inner end cap with the motor and attach with the screws removed previously.
8. Align the screw holes in the inner end cap and attach to the awning case using three (3) M4 x 25
screws and 1 spacer in the front attach hole.
9. Attach the motor and harness wires, matching the wire colors (Blue to Blue and Brown to Brown). Fold
and tuck the wires and connectors to fit inside the outer end cap.
10. Route the wire harness into the cable channels.
11. While holding the lead rail, carefully remove any roller tube supports and arm ties. Allow the lead rail to
extend until the fabric is taut. If the lead rail continues to extend after the fabric is taut, the one way
drive was installed backwards. Retie the arms, remove the motor and orient the one way drive as
shown.
12. To test, restore power then extend and retract the awning.
13. After replacing the motor, it will be necessary to adjust the motor limits (page 13).
14. After testing and adjusting the motor limits, attach the outer end cap.
Fabric Slot
Retaining Screw
Motor
FF027
Plug Outer Endcap
Connect
Motor Wires
Harness Wire
Motor Wire
Thru Hole
In Endcap
Harness Wire
Inside View
Inner Endcap
Harness Wire
Motor
Screws
Endcap
Screws
(x3)
Spacer
“B”
Bearing (ref)
One-Way Drive
B
A
DETAIL
A
DETAIL
B
Motor Wire Spacer