Cardin Elettronica RCQ433-3G, Инструкция пользователя

Страница: 31 / 88

31
MENU: RESTART
This menu allows you to force the modem to restart. When you press the
ENT
button the modem will be
switched off and restarted (after about 10 seconds). This function is available only if the modem is present and
switched on. If you restart the modem with a
M2M card inserted contact with the gateway will be forced in
order to update the receiver reference data.
MENU: INFORMATION
To find out the firmware version of the modem that is currently activated (the acronym [
WF
], [
G
] or [
3G
] will
appear on the display) scroll using the keys until you reach menu “G) INFORMATION” and then press
ENT
. The display will show the modem's complete firmware identification string. To exit the function and return
to the previous menu press any key.
MENU: ROAMING (only with a 2G/3G card)
This setting allows you to decide how you are going to connect to the mobile phone network. If you choose
the setting
DISABLED , the connection will only be authorised using the SIM card operator's network that you
are using. If you choose the setting ENABLED a ROAMING connection will be authorised using any available
operator. The ROAMING connection follows the standard protocol for normal mobile phone devices. Receivers
that are configured to use the SIM VODAFONE-CARDIN will not allow you to change thus setting which will
remain ENABLED .
Attention: The connection to the mobile network in ROAMING may require a certain amount of time, even
a few minutes to establish a connection. If the receiver does not connect within the required amount of time
it will automatically restart the modem and start the procedure over again.
ACTIVATING CHANNELS VIA SMS (only with a 2G/3G card)
This function allows you to activate receiver channels, in all the available combinations and receive channel and
auxiliary input status information by sending
SMS , messages.
The
SMS
messages can be sent from any device but will only be accepted if the devices transmit a valid Remote
Activation Code ( CAR ) which corresponds to the receiver to which the message is being sent. The CAR is a
number that can be modified at will from within the series
0-4’294’967’294
, which makes up the password for
the receiver to accept this particular function.
Modifying the
CAR
code initially set to ‘
0
’ by default, can also be carried out via
SMS
but only if the senders
number is in the SIM telephone address book.
To use commands via
SMS
you must have the
CAR
code as well as the telephone number of the
SIM
. You are
advised to set a personalised CAR code as soon as possible.
The receiver usually carries out the requested operation immediately with the sole exception of when it is
connecting. The answer will be sent after the set time period of 10 seconds (20 seconds on request) has elapsed
from the moment the request was received.
The answer time will be increased by the time required by the telephone operator to forward the message.
• The
SMS must respect the following format:
- Messages without the correct format will be ignored.
- No distinction is made between upper case and lower case letters.
- The message must include the
CAR
code immediately preceded by the hash symbol
#
.
- The new code to be given to the CAR must be preceded by the asterisk symbol * .
• The channels are specified within the message using the identification letters: A, B, C, D. Channel commands
can be sent in three different ways:
-
NORMAL
: only specifying the letter. The command will be executed as if it came from a radio control transmitter;
- ACTIVATE : specifying a letter followed by '1' will force the status to ACTIVATE ;
-
DEACTIVATE
: specifying a letter followed by '0' will force the status to
INACTIVE
.