Canon Puncher Unit-L1, Процедура установки

Страница: 29 / 40

Chapter 1
21
F-1-63
<Finisher-R1/Saddle Finisher-R2>
Check to see that the gap between the upper cover of
the puncher unit and the delivery cover of the host
machine is 3±1.5 mm or less. Take measurements at 2
locations (front and rear); then, check to be surer that
the difference in the gap between the front and the rear
is 1.5 mm or less. Moreover, check to be sure that the
gap running form top to bottom between the finisher
and host machine is parallel when viewed from the
front.
F-1-64
<Finisher-T1 and Saddle finisher-T2>
Check if the clearance between the front/rear cover of
the puncher unit and the delivery cover of the host
machine is within 15+/-3 mm and 10+/-1.5 mm
respectively. Before checking, measure the clearance
at 2 points of the front and rear. Also check if the
clearance between the finisher and the host machine is
parallel from top to bottom when viewed from the
front.
F-1-65
3) If the height/tilt is correct, end the installation work
as instructed in "Work After Making Checks/
Adjustments." Otherwise, make adjustments as
instructed in "Adjusting the Height/Tilt."
3 1.5mm
3 1.5mm
3 1.5mm
3 1.5mm
15 3mm
10 1.5mm
10 1.5mm
15 3mm