Canon Puncher Unit-L1, Процедура установки

Страница: 23 / 40

Chapter 1
15
the puncher unit along the marking [2] found on the
right side of the unit.
F-1-37
9) In the case of the Finisher-Q1/Finisher-Q3/
Finisher-R1, mount the rear cover of the finisher
using 3 screws. In the case of the Saddle Finisher-
Q2/Saddle Finisher-Q4/Saddle Finisher-R2, mount
the rear cover of the finisher using 6 screws; then,
attach the cable cover. For the Finisher-T1 or the
Saddle finisher-T2, attach the upper rear cover
using 4 screws.
10) Mount the upper rear (small) cover of the finisher
using a screw.
11) In the case of the Finisher-Q1/Finisher-Q3/
Finisher-R1, mount the punch lower front cover
fixing plate 2 [1] to the finisher using a screw [2]
(binding; M4x6). (The figure shows the Finisher-
R1.)
MEMO:
In the case of the Saddle Finisher-Q2/Saddle Finisher-
Q4/Saddle Finisher-R2/Finisher-T1/Saddle Finisher-
T2, the punch lower front cover fixing plate 2 is
mounted at time of shipment from the factory. (It is
shaped differently from the punch lower front fixing
plate 2 of the Finisher-Q1/Finisher-Q3/Finisher-R1.)
F-1-38
12) In the case of the Saddle Finisher-Q2/Saddle
Finisher-Q4, mount the lower front extension stay
[1] using 2 screws [2] (binding; M4x6). (Skip this
step if it has already been mounted.)
F-1-39
1.3.3 Preparing the Host
Machine for Installation
0003-0208
Before connecting the finisher to its host machine,
mount the fixing plate that comes with the puncher
unit to the host machine. If the host machine has
already been installed and the finisher has been
disconnected from it as instructed in "Disconnecting
the Finisher from the Host Machine," go to step 3).
1) Cut out the face plate from the host machine.
<When Installing the Finisher-Q1/Finisher-Q3/
Saddle Finisher-Q2/Saddle Finisher-Q4 to an
iRC3100 Series Machine>
1-1) Remove the 4 screws [1], and detach the host
[1]
[2]
[1]
[2]
[2]
[1]