Canon Puncher Unit-L1, Процедура установки

Страница: 28 / 40

Chapter 1
20
machine.
< Finisher-Q1/Finisher-Q3/Saddle Finisher-Q2/
Saddle Finisher-Q4>
Place a ruler on the buffer pass unit as shown and
check to see if it is as indicated on the right side of the
puncher unit (falling between the top and bottom
index lines). Check the height at both front and rear by
referring to the 2 sets of index lines; be sure that the
discrepancy in height is 1.5 mm or less.
F-1-60
<Finisher-R1/Saddle Finisher-R2>
Check to see if the difference in height between the
top cover of the puncher unit and the top edge of the
delivery cover of the host machine is 53±2 mm. Take
measurements at 2 locations at both front and rear;
then, see if the difference in height between the front
and the rear is 1.5 mm or less.
F-1-61
<Finisher-T1 and Saddle finisher-T2>
Check if the distance between the upper cover of the
puncher unit and the upper edge of the delivery cover
on the host machine is within 58+/-2 mm. Measure
the distance at 2 points of the front/rear, and check if
the difference between the front and rear is 1.5 mm or
less.
F-1-62
2) Check the tilt of the puncher unit and the host
machine.
<Finisher-Q1/Finisher-Q3/Saddle Finisher-Q2/
Saddle Finisher-Q4>
Check to see if the gap between the top cover of the
puncher unit and the delivery cover of the host
machine is 3±1.5 mm. Take measurements at 2
locations (front and rear); then, check to see that the
difference in the gap between the front and the rear is
1.5 mm or less. Moreover, check to see that the gap
running from top to bottom between the finisher and
the host machine is parallel when viewed from the
front.
53 2mm
53 2mm
58 2mm