Canon Puncher Unit-L1, Процедура установки

Страница: 27 / 40

Chapter 1
19
F-1-55
<Finisher-R1/Saddle Finisher-R2/Finisher-T1 and
Saddle finisher-T2>
Secure the front fixing plate in place using a stepped
screw after opening the punch front cover [3].
F-1-56
4) Mount the rear cover of the puncher unit using 3
screws.
5) Mount the punch lower front cover fixing plate 1
[1] to the punch lower front cover [2] using a screw
[3] (tapping; M4x12).
6) In the case of the Finisher-Q1/Finisher-Q3/Saddle
Finisher-Q2/Saddle Finisher-Q4, mount the punch
front lower extension cover [4] to the punch lower
front cover using a screw [3] (tapping; M4x12).
F-1-57
7) Fit the positioning pin [1] into the hole of the punch
lower front cover fixing plate 2 [2] to mount the
punch lower front cover. (The figure shows the
Finisher-R1.)
F-1-58
8) Open the punch upper front cover [1], and secure
the punch lower front cover [2] from above using a
screw [3] (tapping; M4x12). (The figure shows the
Finisher-Q1/Finisher-Q3.)
F-1-59
1.3.5 Checking the Height/
Tilt
0003-0210
A finisher may already exist and the height/tilt may
have been adjusted in relation to the host machine.
You may sill have to adjust the height/tilt newly to
make up for changes that may have occurred because
of the installation of the puncher unit. If the height/tilt
is not correct, jams can occur frequently in the
puncher unit pickup assembly. When you have
installed the puncher unit, be sure to go through the
following steps to check and adjust the height/tilt.
1) Check the height of the puncher unit and its host
[2]
[2]
[1]
[2]
[3]
[2]
[1]
[2]
[3]
[4]
[2]
[1]
[3]
[1]
[2]