Canon Puncher Unit-L1, Процедура установки

Страница: 30 / 40

Chapter 1
22
1.4 Making Adjustments
1.4.1 Adjusting the Height/Tilt
0003-0211
If the difference in height between the puncher unit and the host machine or the tilt is not as indicated, make
adjustments as follows; be sure to adjust the height before adjusting the tilt:
A. Preparing for Adjustment
In the case of the Finisher-Q1/Finisher-Q3/Finisher-R1/Finisher-T1, you may need to remove the auxiliary ring and
the rear foot cover of the finisher before adjusting the height; be sure to remove the auxiliary ring without
disconnecting the finisher from its host machine to prevent the finisher from tumbling over.
<Finisher-Q1/Finisher-Q3/Finisher-R1/Finisher-T1>
1) If the height at the rear must be corrected, remove the auxiliary ring and the left rear foot cover.
<Finisher-Q1/Finisher-Q3>
Remove the 4 screws [1], and detach the auxiliary ring [2]. Remove the screw [3], and detach the left rear foot cover
[4].
F-1-66
<Finisher-R1/Finisher-T1>
Remove the 4 screws [1], and detach the auxiliary ring [2]. Remove the 2 screws [3], and detach the left rear foot
cover [4].
[2]
[4]
[3]
[1]