Canon PIXMA MX870 Series, Руководство по обслуживанию

Страница: 15 / 66

full Message on the LCD:
Ink absorber full. Service
required.
Error codes:
5B00: Main ink absorber is
full (overseas).
5B01: Main ink absorber is
full (Japan). (In EEPROM
information print, "5B00" is
printed instead of "5B01.")
- Ink absorber kit and double-sided adhesive tape
(3) Ink absorber counter value in the EEPROM;
reset the ink absorber counter.
8 times Print head
temperature
rise error [5200] The print head temperature
exceeded the specified value.
(1) Print head condition
(2) Head contact pin condition of the carriage unit
(3) Cable connection
(4) Part replacement:
- Print head
- Logic board
- Carriage unit
9 times EEPROM
error [6800]
[6801] A problem occurred in reading
from or writing to the EEPROM. (1) Part replacement:
- Logic board
10 times VH
monitor
error
[B200] The internal temperature
exceeded the specified value.
(1) Head contact pin condition of the carriage unit
(2) Cable connection (especially the carriage FFC)
(3) Part replacement:
- Print head and logic board (Replace them at the
same time.)
- Power supply unit
- Carriage unit
11 times Carriage
lift
mechanism
error
[5110] The carriage did not move up or
down properly.
(1) Foreign material or paper debris that obstructs the
carriage movement;
remove foreign material.
(2) Part replacement:
- Switch system unit
- Carriage unit
12 times APP
position
error
[6A80] An error occurred in the APP
motor.
(1) Foreign material or paper debris around the purge
drive system unit;
remove foreign material, and
confirm that the ink absorber right beneath the
purge drive system unit stays in place and does
not contact the unit.
(2) Foreign material or paper debris around the ASF unit;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- Purge drive system unit
- Logic board
14 times APP sensor
error
[6A90] An error occurred during paper
feeding or purging.
Paper feed
cam sensor
error [6B10] An error occurred in the paper
feed cam sensor during paper
feeding from the cassette, or the
paper absorbing a large amount
of ink jammed in the PF rear
guide.
(1) Jammed paper in the PF rear guide (when a large
amount of ink was absorbed in the paper);
remove the jammed paper and foreign material.
(2) Foreign material or paper debris in the cassette or in
the PF rear guide;
remove foreign material.
(3) Part replacement:
- PF pick-up unit
- Logic board
15 times USB host
Vbus
overcurrent
[9000] The USB host Vbus overloaded. (1) Part replacement:
- Logic board
16 times Pump roller [5C20] The pump roller position cannot (1) Cable connection
12 / 63