Canon imageRUNNER C1325 Series, Руководство по обслуживанию

Страница: 341 / 607

5
5
5-11
5-11
Adjustment > Document Exposure System > Original Exposure and Feed System (Reader) > ADF Unit
Adjustment > Document Exposure System > Original Exposure and Feed System (Reader) > ADF Unit
DADF reading position adjustment
After executing the reading position adjustment with the following service mdoe 1, check the
auto setting value with the following service mode 2 and write the value in the service label.
No. COPIER > FUNCTION > INSTALL >
1 STRD-POS
No. COPIER > ADJUST > ADJ-XY >
2 STRD-POS
T-5-33
T-5-34
Adjustment of the leading edge margin of image at ADF reading (single-sided)
1) Set a test chart on ADF, and give one sheet of single-sided copy.
2) Compare the leading edge registration of the test chart and the copy of the test chart.
Carry out the following process when adjustment is necessary.
3) Select the item in the service mode.
FEEDER > ADJUST >
DOCST
4) Input value, and adjust an image.
• When a copied image moves to the trailing edge: Increase value
• When a copied image moves to the leading edge: Decrease value
• Adjustment unit: 0.1 mm
A
A
Test chart
Copy of the test chart
Copy of the test chart
Test chart
< When a copied image moves to the rear > < When a copied image moves to the front >
Leading edge
of the feeding
direction
Leading edge
of the feeding
direction
Trailing edge
of the feeding
direction
Trailing edge
of the feeding
direction
5) Write the new changed value in the service label.
6) Exit the service mode.
CAUTION:
Confirm that the Degree of a Right Angle is correct after you finish this adjustment.
Adjust again from the Adjustment of the Degree of a Right Angle when the Degree of a
Right Angle is not correct.
T-5-35
F-5-20