Canon imageRUNNER 3530, Справочное руководство

Страница: 128 / 460

Finisher-S1/Puncher Unit-R1 3-20
3
Opti
ona
l Eq
uipme
n
t
•
Do not place anything under the trays of the finisher, as doing so may damage
the trays.
IMPORTANT
•
If the Staple mode is set, the output tray moves downward as the stack of paper that is
output increases in quantity and thickness. Once the output tray has reached its stacking
limit, or after 30 sets of prints have been output, printing and stapling stop temporarily.
Remove all of the stapled prints from the output tray, and printing and stapling resume.
•
Only the following paper sizes can be stapled: 11" x 17", LGL, LTR, or LTRR.
•
You cannot staple envelopes, transparencies, tracing paper, or labels.
•
Do not pull copies or prints out of the output area while they are being stapled. Remove
the copies or prints after they are output to one of the output trays.
NOTE
•
The maximum number of sheets, including cover sheets, that can be stapled together is
as follows:
- LTR
50 sheets (Main Document: 17 to 20 lb bond (64 to 80 g/m 2 ), Cover Page: 17 to 32 lb
bond (64 to 128 g/m 2 ))
- 11" x 17", LGL, LTRR
30 sheets (Main Document: 17 to 20 lb bond (64 to 80 g/m 2 ), Cover Page: 17 to 32 lb
bond (64 to 128 g/m 2 ))
•
If the machine stops while stapling and the message <Load staples.> appears, almost all
of the staples have been used, and the staple cartridge must be replaced. To proceed,
replace the staple cartridge. (See "Replacing the Staple Cartridge," on p. 7-27.)