Canon i-SENSYS MF229dw, Руководство по обслуживанию, Страница: 278 / 308

8
8
8-5
8-5
Service Mode > COPIER > ADJUST > ADJ-XY
Service Mode > COPIER > ADJUST > ADJ-XY
I/O
■ R-CON
COPIER > I/O > R-CON
Address BIT Contents of display ADF
model
Other
P001 0 Sensor state display (DES) Yes No
1 Sensor state display (DS) Yes No
T-8-6
ADJUST
■ ADJ-XY
COPIER > ADJUST > ADJ-XY
Sub item Description
ADF
model
Other
ADJ-X Adjustment value of image reading start position (Horizontal
scanning direction) (X direction)
[Applicable case]
When the reading position of vertical scanning direction in fixed
reading is incorrect
[Adjustment]
• Reduce the setting value when non-image width is larger than
criteria.
• Increase the setting value when the area out of original area is
copied.
• When increment the setting value by 1, the image reading start
position is moved toward trailing edge by 0.1mm.
Setting range: - 30 ~ 30
[Value after RAM clear: 0]
Yes Yes
STRD-POS Adjusting reading position in DF stream reading
[Applicable case]
When the reading position of vertical scanning direction in DF
stream reading is incorrect
[Adjustment]
• When increment the setting value by 1, image reading start
position is moved toward leading edge by 0.1mm.
Setting range: - 30 ~ 30
[Value after RAM clear: 0]
Yes No
ADJ-X-MG Fine adjustment (0.1% precision) of magnification ratio in
Horizontal scanning direction in copyboard reading
±3%
[Applicable case]
When copy output image is larger or smaller than original image
[Adjustment]
Adjust by comparing the copy output and original.
• Increase the value when output image is smaller.
• Decrease the value when output image is larger.
Setting range: - 30 ~ 30
[Factory default settings/ Value after RAM clear] 0
[Caution] This adjustment is targeted to adjust the image position
on copy output.
This may affect to the image of SCAN.
Yes Yes
T-8-7