Canon EOS C300 Mark II, Инструкция по эксплуатации

Страница: 116 / 223

Special Recording Modes
116
Frame Recording Mode
Set the number of frames in advance. We recommend operating the camera remotely or stabilizing the camera,
for example, on a tripod. Sound is not recorded in this mode.
Activating and Configuring
1 Open the [Recording Mode] submenu.
[
3
Recording/Media Setup]
>
[Recording Mode]
2 Select [Frame Recording] and then press SET.
• [FRM STBY] appears at the top of the screen (with [FRM] flashing).
3 Open the [Recorded Frames] submenu.
[
3
Recording/Media Setup]
>
[Special Recording Settings]
>
[Frame Recording]
>
[Recorded Frames]
4 Select the desired number of frames and then press SET.
• Available options are: 1, 3, 6 and 9 frames.
Recording
1 Press the START/STOP button to begin recording.
• The camera automatically records the specified number of frames.
• The tally lamp illuminates.
• [FRM STBY] changes to [
Ü
FRM REC] while recording frames and
[
Ü
FRM STBY] when frames are not being recorded.
• Repeat until you finish recording.
2 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
• Frame recording mode ends and all of the recorded frames are joined together into one clip.
• The tally lamp goes out and [STBY] appears at the top of the screen.
NOTES NOTES
• If Long GOP compression was being used, the bit rate will change automatically to an option with Intra-frame
compression.
• You can use only one special recording mode at a time.
• The number of frames recorded cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• If the system frequency is changed, frame recording mode will be canceled and the [Recorded Frames] setting
will be reset to its default value.
• About the time code during frame recording mode:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode. The time code
advances by the number of frames recorded every time.
- If the time code running mode was set to [Free Run] or the camera was synchronized to an external time
code signal, the time code running mode will be changed automatically to [Rec Run] when interval recording
is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the TIME CODE terminal, REC OUT terminal, MON. terminal or
HDMI OUT terminal.
[
3
Recording/Media Setup]
[Recording Mode]
[Normal Recording]
[
3
Recording/Media Setup]
[Special Recording Settings]
[Frame Recording]
[Recorded Frames]
[1]