Canon CLC5100 Series, Руководство пользователя

Страница: 79 / 290

Chapter 2
2-27
Be sure to disconnect the power plug from the
power outlet. Merely turning off the power switch
will not cut the power.
4) Replace the DC controller PCB.
5) Turn on the power switch.
6) Initialize the RAM on the DC controller PCB. (See
the appropriate instructions.)
7) Turn on and then off the power switch.
2.7.4
Initializing the RAM
on the DC controller PCB
0002-5879
CLC5100 / CLC4000
1) Record the setting of 'OFFSETC/M/Y/K' found in
the second row of page 2 on the EPC screen of
'FUCNT' in service mode.
2) Start service mode, and check to make sure that
'BELTPOS' of 'BLTDRFT' under 'DISP' is
'CENTER'; if not, move the transfer belt to the
center.
3) Execute 'FUNC>DCCON>RAMLR' in service
mode.
4) Turn off the power switch, and disconnect and then
connect the power plug (so that the RAM will be
cleared).
5) Turn on the power switch.
6) If you have replaced the DC controller PCB,
replace the developer according to the instructions
on Replacing the Developer.
7) Enter the value of A recorded on the service label.
(If you have changed other service mode settings
related to the DC controller, enter such settings as
well.)
8) Execute 'REGAPER' of 'INSTALL2' under
'FUNC' in service mode.
9) Enter the setting of 'OFFSET C/M/Y/K' recorded
in step 1) to the following: 'FUNC>DC
CON>POTOFSTC/M/Y/K'.
The settings on the screens of service mode are
cleared when the RAM on the reader controller PCB
is initialized.
T-2-4
The settings on the screens of service mode are
cleared when the RAM on the DC controller PCB is
initialized.
T-2-5
Service Mode Settings Related to the DC Controller
PCB
ADJUST Settings on ADJXY screen
Settings on DOCREC screen
Settings on PROJ screen
Settings on ED/RF screen
Settings on COLADJ screen
Settings on ADJMISC screen
Settings on PRJADJ screen
OPTION Settings on POPT screen
Settings on ONSET on POPT
screen
Settings on REMOTE screen
Settings on DECK screen
ADJUST Settings on PASCAL screen
Settings on FEEDADJ
screen
Settings on ENVSET screen
Settings on HVTR C/M/Y/K
screen
Settings on HVSP screen
Settings on HVFS screen
Settings on HVEL screen
FUNC Settings on DCCON screen
Settings on PUPTMG
screen
Settings on PTHICK screen
Settings on IMGREG screen
Settings on FUSER screen
OPTION Settings on POPT screen
(except ONSET))