Canon CLC5100 Series, Руководство пользователя

Страница: 107 / 290

Chapter 3
3-9
xxD0
Developer (deterioration)
Developing cylinder (rotation failure)
Toner density sensor (faulty)
Developer (inside developing assembly;
stirring fault)
Toner level sensor (faulty)
The value of the toner supply time correction data based
on 'SGNLC/M/Y' is 141 or more for 20 copies or more
during copying sequence.
xxE0
The value of the toner supply time correction data based
on 'SGNLC/M/Y' is 188 or less for 20 copies or more
during copying sequence.
E023
0101
Developing motor (faulty)
DC controller PCB (faulty)
Developing cylinder (rotation failure)
The rotation speed of the C developing motor (M18C)
has deviated from a specific value for 0.1 sec or more
(PLL signal'0').
0201
The rotation speed of the M developing assembly
(M18M) has deviated from a specific value for 0.1 sec
or more (PLL signal '0').
0301
The rotation speed of the Y developing motor (M18Y)
has deviated from a specific value for 0.1 sec or more
(PLL signal '0').
0401
The rotation speed of the Bk developing motor (M18Bk)
has deviated from a specific speed for 0.1 sec or more
(PLL signal '0').
E030
Counter (open circuit)
DC controller PCB (faulty)
Check immediately before the counter turns ON and
OFF.(Normal if the counter drive signal is '0' when the
counter turns ON; normal if the counter drive signal is
'1' when the counter turns OFF.)
E032
Data communication (error between Copy
Data ControllerA1 and copier)
After the copier has generated the copy start signal, count
pulses have not been detected by the data ControllerA1
within a specific period of time.
E040
0001
The cassette lifter motor is faulty.
The DC controller PCB is faulty.
The error detection circuit on the DC controller PCB has
detected overcurrent in the upper cassette lifter motor
drive circuit.
0002
The error detection circuit on the DC controller PCB has
detected overcurrent in the lower cassette lifter motor
drive circuit.
Code Cause
Description