Canon CLC5100 Series, Руководство пользователя

Страница: 63 / 290

Chapter 2
2-11
2.2.5 Adjusting the Pick
Up Timing (paper deck)
0002-3613
CLC5100 / CLC4000
If a discrepancy is found in the image leading edge
margin on 'LTR' copies made using the paper deck,
correct the problem by performing the following
steps:
1) Place three or more sheets of 'LTR' paper in the
paper deck.
2) Start service mode, and select 'FUNC>PUP
TMG'.
3) Execute 'PKADJD'.
The machine picks up a single sheet of paper.
4) Execute 'AKADJD' for a total of three times to
pick up three sheets of paper.
5) When pickup has ended, press 'DSENDD'.
2.2.6
Image Positioning
Correction
0002-5726
CLC5100 / CLC4000
In case image position shifts in every color as well as
the image positioning correction (Service Mode
'FUNC>IMGREG>AUTOADJ') did not provide
any effects on the image shift problem, follow the
below procedures for adjustments.
1) Select the service mode 'TEST>PG>TYPE'. Set to
"6 (lattice pattern)" and press the start button. (A
test print will be printed out.)
2) Select the service mode 'OPTION>POPT>REG
DISP'. Set to "1" and then press the OK key.
3) Press the reset key twice to exit from the service
mode.
4) Press the user mode key to enter the user mode.
5) Select "Image Positioning Correction." (The
display indicates as below.)
ޓ
F-2-19
6) Select "Manual Correction" key.
7) On the test print already made, on the basis of
magenta color, measure how mm other three colors
are shifting from the magenta.
8) In terms of any shifts in main scanning direction,
make an adjustment by changing values of REG
H(rough adjustment) / REGHS (fine adjustment).
REGH: In case the numerical value is increased by
"+16," the position will shift to the rear side by 1
mm.
REGHS: In case the numerical value is increased by
"+32," the position will shift to the rear side by
0.5mm.
9) In terms of any shifts in subscanning direction,
make an adjustment by changing the REGV value.
REGV: In case the numerical value is increased by
"+16," the position will shift to the trailing edge
by 1mm.
10) Select "Auto Correction" key.
11) Press the OK button to exit from the user mode.
12) On the latticepatterned test print, check if the
image is normal.
In case the image position is not good, readjust
the image.
In case the image position is good, go to the
next step.
13) Select the service mode 'OPTION>POPT>REG
DISP'. Set to "0" and press the OK key.
14) Press the reset key twice to exit from the service
mode.
REG-V REG-HS
Y
C
BK
AU TO
A D J U S T M E N T
M A N UA L
A D J U S T M E N T
REG-H
154
150
124
0
3
3
113
128
113
OK
C
ACS
B L AC K
F U L L
C O L O R
O R I G I N A L
RECOGNITION
C E N T E R
S H I F T