Canon CLC5100 Series, Руководство пользователя

Страница: 62 / 290

Chapter 2
2-10
Using the TwoSided Copies as the source of Paper
Loosen the screw [1], and adjust the position of the
paper guide plate so that the standard value is attained.
F-2-15
b. Adjusting the Image Margin
F-2-16
1) Start service mode, and select 'ADJUST > FEED
ADJ'.
2) While the 'FEEDADJ' screen is on, press the Start
key.
3) If the image margin is not as indicated, adjust the
image writing start position in the main scanning
direction using 'UPADJ', 'LOWADJ', 'MULT
ADJ', 'DECKADJ', and 'REFEADJ' and using
'VSYCADJ' in the sub scanning direction.
Then, adjust the nonimage width using 'MARGINL,
R, T, B'.
(For details, see. "SERVICE MODE.")
2.2.4 Adjusting the Image
Reading Start Position
(ADJXY)
0002-3604
CLC5100 / CLC4000
F-2-17
1) Start service mode, and select 'ADJUST > ADJ
XY'.
2) While the 'ADJXY' screen is on, press the Start
key.
The appropriate copying mode will be set
automatically, and a copy is made with a shift of
about 20 mm as shown in the Figure.
3) If a portion of the image is missing, decrease the
setting of 'ADJX' and 'ADJY'.
4) If an area outside the image area is copied, increase
the setting of 'ADJX' and 'ADJY'.
5) Press the Start key once again, and check the
output.
6) Press the Reset key.
F-2-18
[1]
<M> ADJ-XY <S> <R> READY <P> READY <F>
DISP
ADJUST
COUNTER
FUNC
OPTION
ADJ-Y
ADJ-S
ADJ-J
TEST
ADJ-X
xxxx
xxxx
xxxx
xxxx