Canbuilt OPT-5405, Руководство пользователя

Страница: 17 / 22

To check the aimer for accuracy, place a car in front of a screen or a flat vertical wall, at a distance of 25 feet (7.6m).
Trace or mark with tape the lines as shown in the figure below.
If the headlamp mounting height of the vehicle used for the test is more than 36in, then a Nominal Vertical Aim line at the distance
specified in the Table 1 shall be traced.
Perform the preparation for headlamp aim as detailed.
Proceed to aim the lower beam as explained in next page.
VERTICAL CENTERLINE
AHEAD OF LEFT
HEADLAMP
VERTICAL CENTERLINE
AHEAD OF RIGHT
HEADLAMP
CAR AXIS
SCREEN MARKING
HEIGHT OF LAMP CENTERS
Calibrating the Aimer
HIGH-INTENSITY ZONE (SHADED AREA) OF A PROPERLY AIMED
LOWER BEAM ON THE AIMING SCREEN IN FRONT OF VEHICLE
VERTICAL CENTERLINE
AHEAD OF LEFT
HEADLAMP
VERTICAL CENTERLINE
AHEAD OF RIGHT
HEADLAMP
CAR AXIS
AIMING the LOWER BEAM
HEIGHT OF LAMP CENTERS
OR NOMINAL VERTICAL AIM
(SEE TABLE 1)
CALIBRATING THE SCREEN
AIMING LOW BEAM HEADLAMPS
Aim Low Beam Headlamps so that the top edge (the cutoff) of the high-intensity zone is at the NOMINAL VERTICAL AIM line, and the left
edge of the high-intensity zone is at the vertical centerline of the headlamp.
Page 16 - Calibrating the Aimer
Canbuilt Mfg.
Perfect Night Vision.....