corporate
t
800.900.1730
f
630.889.8106
3609 Swenson Ave.
St. Charles, IL 60174
CONFIDENTIAL
THIS DOCUMENT IS THE PROPRIETARY PROPERTY OF FC LIGHTING, INC. ANY UNAUTHORIZED TRANSFER, USE OR REPRODUCTION IS STRICTLY PROHIBITED.
©2013 FC LIGHTING, INC.
FCW5806
-
INSTALLATION INSTRUCTIONS
CAUTION: BEFORE CONNECTING THE FIXTURE TO A POWER SUPPLY, MAKE SURE THE POWER IS SWITCHED OFF.
DETAILED ILLUSTRATION
GENERAL
:
1. Before starting the installation, make sure all electricity has been turned off
and electrical breaker has been locked out and tagged out.
2. To ensure the success of the installation, be sure to read these instructions
and review the diagrams thoroughly before beginning.
3. All electrical connections must be in accordance with local codes,
ordinances, or the National Electrical Code.
NOTE
: The important safeguards and instructions appearing in this manual
are not meant to cover all possible conditions and situations that may occur.
INSTALLATION:
A)
Standard Canopy
installation Fig. A
1) Remove (3) Set Screws from base of fixture to remove base mounting
plate from the Canopy Housing
2) Fasten Mounting Plate to desired surface.
3) Refasten Mounting Canopy to secured Mounting Plate.
4) Adjust fixture tilt and swivel to desired light angle.
B)
Integral Ballast Box
(IBB) Canopy installation Fig. B
1) Fixture comes assembled and only needs to be fastened to mounting
surface.
2) Use 4 holes at the base of the Mounting Plate to fasten fixture to
desired mounting surface.
3) Adjust fixture tilt and swivel to desired light angle.
NOTE:
Installing fixtures as shown here requires no silicone sealant.
Fig. A, fixture power cord does not pass through Mounting Canopy.
Fig. B, Mounting Canopy and Mounting Plate are rubber gasket sealed.
[
ø
6.0 in ]
[ 2.5 in ]
[
ø
6.25 in ]
[ 10.0 in ]
[ 6.5 in ]
A
B
Fixture
Mounting Plate
Mounting Plate
Adjust Swivel
Adjust Tilt
Power Cord
Mounting Canopy
Integral Ballast Box
Mounting Canopy
Set Screws
IBB
5.04 in
7.63 in
