Electro-pneumatic Regulator ER100
Instruction Manual
rev. 2.0
page 26 / 38
4.4.1.2.
Parallel Type Input Signal Selection
In case of parallel input selection
※
Factory setting
After data is settled, the setting mode is canceled to return to
screen F1.
SET
For two seconds or longer
The input signal selection
setting mode is canceled to
return to screen F1.
SET
For two seconds or longer
In case of direct memory input selection
Transition to direct memory input setting mode
(See section 4.4.1.4 “Direct Memory Input Setting.”)
SET
For two seconds or longer
*For the relationship between the input signal and control pressure, refer to Section 7.1 “Relationship
Between Parallel Type Input Signal and Control Pressure.”
4.4.1.3.
Preset memory Input Setting
Note: In the state of screen F1 preset memory input, press and hold the [SET] key at least
for two seconds.
The preset memory input signal setting
mode is canceled to return to screen F1.
After the data
is inserted,
the next
number is
After the data is inserted, the setting
mode is canceled to return to screen F1.
SET
For two seconds
or longer
SET
For two seconds
or longer
SET
For two seconds
or longer
SET
For two seconds
or longer
Enter the target value.
key: Shift the cursor.
key: Increase the value.
Enter the target value.
key: Shift the cursor.
key: Increase the value.
*For the relationship between the input signal and preset memory, refer to Section 7.2 “Relationship
Between Preset Memory and Input Signal.”
4.4.1.4.
Direct Memory Input Setting
Enter the target value.
key: Shift the cursor.
key: Increase the value.
After the data is inserted, the setting mode is canceled to return
to screen F1.
SET
For two seconds or longer
*In the state of screen F1 “Direct Memory Input,” press and hold the [SET] key at least for two seconds.
